Sữa lỗi an abnormal condition has occurred etabs năm 2024
Một lỗi phổ biến trong Etabs v18 là không hiển thị point khi vẽ hoặc khi lựa chọn dầm mà không hiển thị dầm nào đã được chọn. Dưới đây là cách khắc phục Show
Để khắc phục lỗi này các bạn chọn vào Menu Option > Graphics Mode > Standard Graphics như trong hình dưới đây. This error is typically caused by registry entries becoming corrupted during the installation and can be resolved by running a FixIt tool from Microsoft. Another approach to resolve this error is to uninstall previous versions of the software (including any evaluation versions that may have been installed), rebooting the machine and performing new installation after the reboot. Suggested resolution when this error is triggered by copying StandaloneKey.exe.config file during installationIf, in SAP2000 or CSiBridge V17, this error generates the following error message, you can try the suggested resolution listed below (please note that issue should be fully resolved for SAP2000 and CSiBridge V18 and higher): Error message:
Troubleshooting:
Error # 1722Error Message: Error 1722. There is a problem with this Windows Installer package. A program run as part of the setup did not finish as expected.
Windows errors and errors with error codesWindows and code-based errors are listed as follows:
File Write Error # 4Error Message: File Write Error # 4. The disk may be full, there may be a sharing conflict, you may have insufficient rights, or some other error may have occurred. File Write Error # 5Error Message: File Write Error # 5. The disk may be full, there may be a sharing conflict, you may have insufficient rights, or some other error may have occurred.
Error # 6See below. Error # 10
Error # 20
Error # -32
Error # 41Error Message: Error 41: Allocate Error # 41
Error # 112Error Message: ERROR_DISK_FULL 112 (0x70) There is not enough space on the disk.
Error # 430 when exporting to ExcelTo resolve error # 430, on the machine producing the error, please complete the following process:
Error # 480
Analysis errorsAnalysis errors are listed as follows: Cannot run analysis!
Negative Jacobian error
Error auto meshing area object
Error in computing frame section locations
Members are too closeError Message: Members are too close.
No unrestrained massError Message: The structure has no (unrestrained) mass; no Eigen modes can be found. This error message occurs when zero weight and mass are assigned to the material definition. The assignment of nonzero values should resolve the issue. Other errorsAdditional errors which may occur are listed as follows: Database formatting data is corruptError Message: Database formatting data is corrupt and has been refilled by the program. Please check the Options > Set Program Default Display Units command.
Overflow errorOverflow error means that a calculation occurred that generated a number larger than can be handled by the CPU, such as division by near zero or some other math function. Usually this occurs in the graphics and is of no concern. This error may be reported with Error Code 6 as Error 6. Some additional information about this error is provided in the Overflow (Error 6) article in Microsoft Documentation. Installation Wizard errorsNo network connection is availableYou may receive this error even when the computer is connected to internet. The Installation Wizard checks whether the computer has both ports 80 and 443 open. If they are not open, then the "No network connection is available" error message is displayed. The resolution of this error would be to open these ports. You may also find it useful to review the Error 'Port 80 (or 443) is not responding' when running activation tool for web-activated licenses article. For products released prior to 2/4/2014, ports 8080 and 8443 were used instead of ports 80 and 443. If you are using products released prior to 2/4/2014, please upgrade to the latest version as ports 80 and 443 are typically opened on most systems by default. |